Common problems
Fixes for the problems lobby owners hit most: nothing happens, players cannot build, the hotbar is missing, no player counts and endless parkour that does nothing.
Find your symptom, then follow the fix.
The plugin does not start#
ExyliaLib is required. Without it the console says where to download it and ExyliaLobby stays off until it is installed and the server restarts. See Install ExyliaLobby.
Nothing happens to players#
The lobby rules apply only inside the lobby areas. Open /lobbyadmin, Areas, and check that the world, box or region you stand in is listed. See Define the lobby areas.
A module does nothing#
chat and onboarding are off by default. Open /lobbyadmin, Modules and switch them on. See Switch modules on and off.
I cannot build in the lobby#
Protection applies to everyone, admins included. Run /lobbyadmin build (permission exylialobby.build) to switch build mode on, and off again when you finish.
The hotbar buttons do not show#
- ExyliaPracticeCore is installed: its own lobby hotbar stays in charge. Set
force: truein the hotbar module to show this one. - PacketEvents is missing: the buttons are drawn as an overlay and need it.
- The player is not inside a lobby area.
- A button that depends on a module is drawn only while that module is on.
Everyone can see everyone#
Visibility needs PacketEvents. Without it the toggle does nothing.
The server selector shows no player counts#
Counts and status come from the proxy through ExyliaLib. Check the network link in ExyliaLib, and that server in each entry matches the id the proxy uses. See Install ExyliaLobby.
Endless parkour does nothing#
It needs PacketEvents, an endless area (/lobbyadmin parkour endlessarea <name>) and the mode enabled under modes. See Build parkour.
A player lost items or effects after leaving the lobby#
They should not: whatever a module changes is given back when the player leaves, quits or the module is switched off, and the state module keeps the original on the player so a crash does not lose it. If it happens, switch on debug in config.yml and report the log.
Something missing on this page? Tell us on Discord